VIGILANT500/I OM.

– High number of entry and exit movements and low consumption

– Possibility of operation even in the event of a power failure thanks to control with UPS group

– Quick and easy to install, also thanks to the foundation box, which can be assembled on site without welding

– With RS485 communication bus and Ethernet connection via TCP/IP protocol

– Integrated encoder and current sensor for obstacle detection

– With vandal-proof function for detecting forced actuation, whereupon the bollard is reset and an alarm is activated

– PLUG&PLAY connection between control unit and bollard

– Cover compliant with EN124 (40 t) and built-in light ring

Specifiche

Product features: VIGILANT500/I OM.

Cylinder height	500 mm
Cylinder diameter	200 mm
Exit time	4 s
Running-in time	3 s
Power supply	230 Vac / 50/60 Hz
Motor supply	24 Vdc
Motor power consumption	6 A
Motor power	90 W
Standby consumption	10 W
Consumption during run-in	1 A
Daily cycles	1.200
Impact resistance	11.000 J
Breaking strength	180.000 J
Operating temperature	-20°C / +50°C
Protection class	IP68
Brake	5 N
Weight (without foundation box)	84/90 kg

Controls

CP1 OMOLOGATA

Mains power supply: 230/250 VAC – 50/60 Hz – with double input transformer / With AUT device for automatic retraction in case of power failure / With ALL UP/ALL DOWN control device / 8 inputs for commands / 4 control inputs for loop detectors / 2 static 24 V outputs / 8 programmable dip-switches for various configurations / LED diagnostics / Ethernet connection via TCP/IP protocol in LAN network / Communication between bollard controller and CP controller via RS485 communication bus / Version with batteries for automatic operation in the event of a power failure / Integrated electronics for operating two traffic lights (no CP.TL controller required) / 6 different modalities for operating magnetic loops / Pre-equipped for any type of command

CP1K OMOLOGATA

CP2 OMOLOGATA

CP2K OMOLOGATA

[9176912] Mains power supply: 230/250 VAC – 50/60 Hz – with double input transformer / With AUT device for automatic retraction in the event of a power failure / With ALL UP/ALL DOWN control device / 8 inputs for commands / 4 control inputs for loop detectors / 2 static 24 V outputs / 8 programmable dip-switches for various configurations / LED diagnostics / Ethernet connection via TCP/IP protocol in LAN network / Communication between bollard control unit and CP control unit via RS485 communication bus / Version with batteries for automatic operation in the event of a power failure / Integrated electronics for controlling two traffic lights (no CP.TL control unit required) / Pre-fitting for any type of control unit

CP4 OMOLOGATA

CP4K OMOLOGATA

Accessories

	LD1/LD2 Metal mass detector with one channel (LD1), with two channels (LD2).
	L50 Cable for magnetic loop (50 m).
	SIR1 Detector for two-tone sirens, those used by emergency vehicles. Sends a command to retract the bollard when active sirens are detected.
	RES Heater for cold climate zones (accessory supplied pre-assembled).
	BUZZ Acoustic warning signal (accessory supplied pre-assembled).
	KTOOLS Installation kit.
	CA500A Foundation box made of cataphoresis-treated steel for VIGILANT 500 / HYDRA 500. Quick assembly with the screws included in the scope of delivery.
	TOP20 Cover for foundation box.
	C05/10/15/20/25 Cable with connector L=5/10/15/20/25 m.